ESICS: Pole Properties
In this section, the user can assign properties such as type, and diameter to the parent pole and offset poles. the length of the offset pole is also prompted to the user solely to calculate the weight of the offset pole supported by the bracket and parent pole. The default value of the length of the offset pole is set to 2500 mm but the user can change this value in 500 mm increments. keep in mind that once a symmetrical bracket is selected the same properties are assigned to both offset pole one and offset pole two. The user also can choose the type of the main parent structure between, pole, angle and square. This selection is dependent on the type of bracket. You can check this information in the "Bracket Type" debug mode (Figure 10) where all the properties of the bracket are explained.
Figure 10. Bracket Type Debug Mode